NEC SIGMABLADE N8406-035, Руководство пользователя

Страница: 54 / 62

(English)
34
How to Install and Remove Option SFP Modules
Below explained are how to install and remove the Option SFP Modules in and from the N8406-035,-036 10Gb
Pass-Through Card.
IMPORTANT:
- If you store or transport the Pass-Through Card
with the SFP Modules installed, keep all vacant LC
connectors covered with the attached dust covers
to keep the connectors clean. (N8406-024,-037)
- Do not allow the connector to make contact with
any surface. If you damage the end of the cable, it
may lower optical output and sensitivity and cause
the cable to malfunction.
- Align the SFP Module straight to the slot. To avoid
damage to the module, do not force it into the slot.
Dustproof cover
SFP Module
Avoid direct look into the laser beam.
The N8406-024,-037SFP Module is classified as a Class 1 Laser Product. A class 1 laser will not be
harmful to the human body. However, do not look directly into the SFP module port during operation.
Keep any vacant LC connector covered with a dust cover (rubber cap) when you do not use it or you
transport it.
How to Install the SFP Module
Remove the connector cover attached SFP+ port on the Pass-Through card.
IMPORTANT:
Keep the removed connector cover carefully.
1
Insert the connector of the SFP Module to
the SFP port in the Pass-Through Card
until it stops.
2
NOTE:
Insert the connector to the SFP port until
it clicks, without pulling down the lever. If
you insert with the lever pulled down, a
communication failure may occur.
Di
re
ct
io
n
to
in
se
rt
Pass-Through Card
SFP module
SFP+ port
WARNING