NOTES ON SAFTY
3
Safety Notes
This section provides notes on using your product safely. Read this section carefully to ensure proper and
safe use of the product. For symbols, see "SAFETY INDICATIONS" provided earlier.
Do not use this product for services where critical high availability
may directly affect human lives.
This product is not intended for use or control in the facilities or devices concerning
human lives, including medical devices, nuclear facilities and devices, aeronautics
and space devices, transportation facilities and devices; and facilities and devices
requiring high reliability. NEC assumes no liability for any accident resulting in
personal injury, death, or property damage if this product has been used in the above
conditions.
Do not disassemble, repair, or modify this product.
Never attempt to disassemble, repair, or modify this product on any occasion other
than described in this manual. Failure to follow this instruction may cause an electric
shock or fire as well as malfunctions of this product.
Do not use this product if any smoke, odor, or noise is present.
If smoke, odor, or noise is present, immediately turn off the system and disconnect
the power plug from the outlet, then contact your service representative. Using this
product in such conditions may cause a fire.
Do not insert a wire or metal object.
Do not insert a wire or metal object into this card.
There is a risk of an electric shock.
Use the devices only in the specified areas.
This product should be installed in the dedicated Blade Enclosure for their uses. Do
not install this product in a chassis other than the Blade Enclosure. Failure to follow it
may result in fire and/or electric shock to occur.
Do not use the equipment in the place where corrosive gases exist.
Make sure not to locate or use this product in the place where corrosive gases (sulfur
dioxide, hydrogen sulfide, nitrogen dioxide, chlorine, ammonia, ozone, etc) exist.
Also, do not set it in the environment where the air (or dust) includes components
accelerating corrosion (ex. sulfur, sodium chloride) or conductive metals. There is a
risk of a fire due to corrosion and shorts of an internal printed board.
Do not look at laser directly. (N8406-037)
The N8406-037 10GBase-SR SFP+ module uses class-1 laser beam for
communication.
This laser beam has little impact on the human body. However, do not look into the
SFP module port during operation. Keep any vacant LC connector covered with a
dust cover (rubber cap) when you do not use it or when you transport it.
WARNING
Содержание SIGMABLADE N8406-035
