NEC QX-S5500 Series, Руководство по установке

Страница: 14 / 80

Installation Guide
QX-S5500 Series Ethernet Switches
1
Product overview
II. Rear panel
Figure 1-8 QX-S5526T rear panel
(1) (2) (3) (4) (5)
(1) Grounding screw (2) Hot swappable power module 1
(3) Hot swappable power module 2 (4) Interface module slot 1 (MOD1)
(5) Interface module slot 2 (MOD2)

NOTE:

The QX-S5526T switch comes with the power module slots empty and the filler modules for the slots as
accessories. You can select AC power module or DC power module for your switch as needed.

You can install one or two power modules for the switch.

The QX-S5526T provides two power module slots on its rear panel, with only an AC power module installed
in Hot swappable power module 1 upon device delivery while a blank panel on Hot swappable power
module 2.

You can install a power module, which can be AC power module or DC power module, in Hot swappable
power module 2 to serve as a backup.

Please refer to "Expansion interface module" about a practicable Interface module expansion interface
card by an Interface module slot.
1.3 Ports
1.3.1 Console Port
Each QX-S5500 series provides one console port on the front panel. Table 1-2 describes
the console port specifications. You can connect console port to a PC and configure,
manage, and monitor the device.
Table 1-2
Console port specifications
Item Specification
Connector type RJ-45
Compliant standard EIA/TIA-232
Transmission baud rate 9600 bps to 115200 bps (defaulting to 9600 bps)
Service

It can be connected to an ASCII terminal.

It can be connected to a serial port of a local PC running terminal
emulation program.
1-6