5-6 Setting System Board Jumpers
3.
Locate the BIOS Recovery jumper on the system board
(see the figure “Locating system configuration
jumpers” earlier in this chapter).
4.
You may have to remove any installed expansion
boards to access the jumpers (see the Option
Installation Center in your online documentation).
5.
Set a jumper on the BIOS Recovery pins.
6.
Replace the system unit cover (see the Option
Installation Center in your online documentation).
7.
Connect system power cables and monitor.
8.
Power on the system. The system displays a system
configuration error message.
9.
Power off, unplug the system and monitor, and remove
the cover.
10.
Remove the jumper block from the BIOS Recovery
pins.
11.
If you removed any expansion boards, replace them
(see the Option Installation Center in your online
documentation).
12.
Replace the system unit cover. Reconnect system
power cables and peripheral devices.
13.
Power on the system.
14.
Run Setup (see Chapter 4, Setting System Parameters).
Содержание POWERMATE
Страница 115: ...Index 5 ...