Installing Options 4-37
Removing the bracket cover
A – Bracket Cover Side Tabs
C – Access for Unlatching Bracket Cover
B – Metal Panel
D – Blank Panel
4.
Slide the new device into the front of the bracket, under the diskette
drive, connector end first. Be sure to orient the device so that any
labels on the device are right side up for your configuration.
5.
Secure your new device to the bracket using the following general
information and the specific instructions that come with the device.
!
Some devices are secured to the sides of the bracket with four
screws, two to a side, similar to the diskette drive.
!
Other devices, such as a Zip drive, are secured to the bottom of
the bracket with three screws (see the following figure). Be sure
to install the screws in accordance with the manufacturers
instructions for the device or you might damage the device.
6.
Slide the bracket into the empty 5 1/4-inch accessible bay until the
bracket locks in place. Note that the bracket fits only in the bottom
bay.
7.
Connect signal and power cables to the new device and the diskette
drive.
8.
Install the front panel and cover (see “System Unit Covers”).