NEC PG-FPL, Руководство пользователя, Страница: 61 / 102

61
Chapter 4 Using The GUI Software
Preliminary User’s Manual U17271EE1V0UM00
<4> Operation Mode
The setting of "Operation Mode" may divide the flash memory of some target devices into blocks
or areas.
This menu is used to select an operation mode of the flash memory. Some devices do not have
the block and area division modes, and some devices have only one of the modes. In these cases,
a nonexistent mode is unchoosable.
Figure 4-10: Setup Window - Operation Mode
[When Chip is selected]
The entire flash memory area of the target device is subject to rewrite processing.
[When Block is selected]
Specify the Block number range subject to rewrite processing by using Start/End.
The Start/End list boxes display the Block numbers where the flash memory of the target device is
configured.
[When Area is selected]
Specify the Area number range subject to rewrite processing by using Start/End.
The Start/End list boxes display the Area numbers where the flash memory of the target device is
configured.
[Show Address check box]
Specify whether numbers or addresses are displayed in the Start/End list boxes.
If this check box is checked, addresses are displayed.
If this check box is not checked, numbers are displayed.