NEC PG-FPL, Руководство пользователя, Страница: 19 / 102

19
Chapter 2 Hardware Installation
Preliminary User’s Manual U17271EE1V0UM00
2.2.6 Connection procedure
1. Set the MODE switch according to the power supply of the target system.
Caution: Be sure to set the MODE switch before making connections with the host machine
and target system.
If connections are made based on an incorrect setting, this product and target sys-
tem can be damaged.
Figure 2-4: MODE Switch Setting
2. Connect the host machine with the FPL via the USB cable. (Check that the Power LED is turned
on in green.)
Cautions: 1. Be sure to perform this step before making a connection with the target system.
If connections are made in an incorrect order, this product and target system can
be damaged.
2. If the MODE switch is set to MODE2, MODE3, or MODE4 (power is supplied from
the FPL), the voltage set on the VDD/VDD2 pin is output when the FPL is con-
nected with the host machine.
3A. (When a connection is made with a target system that has a 16-pin connector usable with the FP4
connector)
<1> Connect the tip of the target cable with the target connector of the FPL-FA.
Remark: The FPL-FA is connected with the target cable at the time of shipment.
<2> Check that the power to the target system is not turned on.
Caution: Check that the power to the target system is not turned on before connecting the tar-
get cable. If the target cable is connected after the power to the target system is
turned on, this product can be damaged.
<3> Connect the FP4 connector with the connector installed on the target system.
Caution: When MODE2, MODE3, or MODE4 is set, VDD/VDD2 is output from the FP4 connec-
tor.
Before inserting or removing a device on the target system, be sure to detach the FP4
connector.
<4> Be sure to turn on the power to the target system.
(When MODE2, MODE3, or MODE4 is set, power is supplied from the FPL, so that this step
is not required.)
Set the MODE switch
1: Target / Target
2: 3.3 V
/ N.C.
3: 5 V / N.C.
4: 5 V / 3.3 V