NS170 User Guide - Upgrading Your Server
4 - 28
Caution
■
The DIMM is easily affected by static electricity. Handle the
DIMM after making your body contact with a metallic frame
section of the server to discharge the static electricity on
your body. Do not make bare hands contact with terminals
and components on the DIMM. In addition, do not put the
DIMM on a desk directly. See "Static Precautions" for details
of the static electricity.
■
Do not use any DIMM not approved by NEC. If an unap-
proved third party's DIMM is installed in the server, not only
the DIMM but also the server itself may be defected. You will
be charged by any repair of a malfunction or defect caused
by such a device within the warranty period.
Installing DIMMs
Figure 4 - 24 : DIMM Module
Install DIMMs one by one in the ascending order of DIMM slot numbers.
1.
Read section “Preparing Your Server for Upgrade” on page 3
2.
Remove the right side door. See “Removing or Installing the Right Side Door”
on page 4
3.
Gently lay the server on its left side.
4.
Locate the socket in which a DIMM is installed.
5.
Open the levers at both ends of the socket.
Caution
■
To avoid damaging the lever, do not apply an excess force
onto the lever.
■
Use extreme care when installing a DIMM. Applying too
much pressure can damage the socket. Keyed DIMMs insert
only one way.
