NEC NC2041L, Руководство по установке

Страница: 72 / 108

97
4. LCD Menu
This chapter describes the menus displayed in the LCD screen on the projector’s control panel and their functions. For basic
operations of menus, refer to the projector’s operation manual.
4-1. List of Menu
Menus in parentheses are menus for our service personnel. Normally, these menus cannot be used.
Main menu Submenu Description
Reference
page
Title Select “Title Memory Name” Selects the title of the signal to be projected. 101
TEST Pattern Selects the test pattern to be projected. 101
Configuration Light Setup Adjust Adjusts light source brightness. 102
Lens Control Lens Position Adjusts the position of the projected screen. 102
Focus Zoom Adjusts the size and focus of the projected screen. 102
Reset (FactoryDefault) Returns the settings to their default values. Selects between
preset buttons and titles only, LAN settings only and all settings. 103
Filter Cleaning Initializes the air filter usage time (for confirming the filter
cleaning time). 103
(Fan Usage) Initializes the usage time of the fan. 104
(Light Usage) Initializes the usage time of the light source. 104
(Phosphor) Initializes the usage time of the Phosphor. 104
(Diffuser) Initializes the usage time of the Diffuser. 104
(Douser Count) Resets the number of times the douser has been used. 104
(Setup) Douser Setup Sets the douser open/close state. 105
Panel Key Lock Locks the buttons on the projector’s control panel so that they
cannot be operated. 105
Auto Key Lock Enables or disables Auto Key Lock. 106
Off Timer Sets the time until the projector power is turned off automatically. 106
Message Sets the time to display the message indicating the air filter
cleaning cycle. 106
Silent Mode Selects whether to use the rear status indicator, buzzer,
indicators on the control panel and backlight. 107
Remote Sensor Set the remote control receiver on the front and rear of the
projector. 107
Projector ID You can operate multiple projectors separately and
independently with the single remote control that has the
Projector ID function. If you assign the same ID to all the
projectors, you can conveniently operate all the projectors
together using the single remote control. 108
Installation (Option Slot) Configures the device installed in slot (only when the projector is
in standby mode). 109
(Orientation) Sets the projection method and cooling fan operating mode. 109
Lens Type (Note) This function can not be used. 109
Lens Calibrate
(Note) This function can not be used. 109
Lens Center (Note) Moves the lens shift position to the center (only when the
projector power is turned on). 110
(Baudrate) Sets the PC control terminal (RS-232) data transmission speed
(bps). 110
(Date/Time) Sets the date and time on the projector. 110
(New Router Setup) Sets the router with the default settings when the router built-in
the projector has been replaced. 111
(Fan Speed Mode) Sets the cooling fan operating mode. 111
(Service) Displays the Service man Menu. 111