NEC N8551-28F, Инструкция по эксплуатации

Страница: 35 / 48

Built-in AIT 17
Cleaning
To keep the driver in the best condition, regular cleaning is required.
Cleaning the read/write head
When the STATUS LED is blinking (repeating a long ON and a short ON), clean the read/write
head within the driver.
Set the provided cleaning cartridge in the driver, following the procedure described in “Handling”
in “Setting the AIT Data Cartridge”.
When set in the Built-In AIT, the cleaning cartridge automatically starts cleaning the head.
After cleaning, the cleaning cartridge is automatically ejected (which requires about 35 seconds
after starting cleaning). Remove the cleaning cartridge.
Important
• Use our “AIT Cleaning Cartridge” to clean
the Built-In AIT. If you use a cleaner of other
manufacturer, a machine failure may be
caused.
• Do not touch the cleaning cartridge tape
surface or rewind the tape.
• You can use the cleaning cartridge for about
70 times. When the STATUS LED blinks (at a
given interval) during cleaning, the cleaning
cartridge tape comes to the end. (Eject the
cleaning cartridge tape and check that all the
tapes are wound around the right reel.)
Purchase a new cleaning cartridge tape.
Hint
✎
Before using the AIT data cartridges, you should clean the read/write head using the cleaning
cartridge once a week. (The cleaning frequency varies depending on the operating environment
(generation of dust and dirt) and the operation frequency. When using the Built-In AIT every day in
a typical office, a weekly cleaning is recommended.)