NEC N8551-28F, Инструкция по эксплуатации

Страница: 27 / 48

Built-in AIT 9
Important
• When using the rails, adjust their
mounting positions so that the front
cover of this device is aligned with
the front covers of the other
standard components (such as the
CD-ROM).
• Always use the screws that are provided with this device. The screws that
are provided with this device are millimeter screws (length: 5.0 mm; length
below washer: 3.5 mm). Using screws that are longer than the screws that
are provided with this device could result in damage to the device.
2
Connect the cables to the drive as
shown below.
Important
• Confirm the SCSI ID and other settings before installation.
• The factory default setting of the SCSI ID is 4. Make sure this ID is not used by any other
device in the system.
• This unit does not have a built-in terminator. When connecting this unit to the last terminal of
the SCSI bus terminal, attach a terminator to the end of the SCSI cable.
3
Attach the cover to the basic processing unit. Plug the power cable to the outlet.
4
Turn on the basic processing unit.
3.5 mm
millimeter screw
DC power cable
(unused power
supply connector in
the computer)
SCSI interface cable
Use screws to secure
the upper rail.
Rails
Front cover