NEC N8406-023, Справочник по командам

Страница: 37 / 156

N8406-023 1Gb Intelligent L3 Switch Command Reference Guide (ISCLI) 37
Layer 3 information
The following table describes basic Layer 3 Information commands. The following sections provide more detailed
information and commands.
Table 26 Layer 3 information commands
Command Usage
show ip route
Displays all routes configured in the switch.
Command mode : All except User EXEC
show ip information
Displays general IP information.
Command mode : All except User EXEC
show ip arp
Displays Address Resolution Protocol (ARP) Information.
Command mode : All except User EXEC
show ip ospf information
Displays the OSPF information.
Command mode : All except User EXEC
show interface ip < 1-256 >
rip
Displays RIP user‘s configuration.
Command mode : All except User EXEC
show layer3 information
Displays IP Information. IP information, includes:
IP interface information: Interface number, IP address, subnet mask,
VLAN number, and operational status.
Default gateway information: Metric for selecting which configured
gateway to use, gateway number, IP address, and health status
IP forwarding information: Enable status, lnet and lmask
Port status
Command mode : All except User EXEC
show ip igmp groups
Displays IGMP Information.
Command mode : All except User EXEC
show ip vrrp information
Displays the VRRP Information.
Command mode : All except User EXEC
show layer3
Dumps all switch information available from Layer 3 memory (10K or more,
depending on your configuration).
If you want to capture dump data to a file, set your communication software on
your workstation to capture session data prior to issuing the dump commands.
Command mode : All except User EXEC
Route information
Using the commands listed below, you can display all or a portion of the IP routes currently held in the switch.
Table 27 Route Information commands
Command Usage
show ip route address < IP address >
Displays a single route by destination IP address.
Command mode : All except User EXEC
show ip route gateway < IP address >
Displays routes to a single gateway.
Command mode : All except User EXEC
show ip route type
{indirect|direct|local|broadcast|martian
|multicast}
Displays routes of a single type.
Command mode : All except User EXEC
show ip route tag
{fixed|static|address|rip|ospf|broadcast
|multicast|martian}
Displays routes of a single tag.
Command mode : All except User EXEC
show ip route interface < 1-256 >
Displays routes on a single interface.
Command mode : All except User EXEC
show ip route
Displays all routes configured in the switch.
Command mode : All except User EXEC