2. System BIOS Setup
Express5800/T120e User’s Guide
161
Chapter 3 Setup
2.
System BIOS Setup
This section describes how to configure Basic Input Output System (BIOS).
Before you install the server and add or remove optional devices, make sure you have read and understood
this section to configure properly.
2.1
Overview
BIOS Setup Utility (SETUP) is a utility to do basic hardware settings. This utility is pre-installed in the Internal
Flash Memory in the server as standard and can be run without requiring a media for boot.
BIOS settings were configured with optimal settings before the server was shipped to you. Therefore, in most
of cases, you should not need to use the SETUP.
Use only when the case applies to any of cases
described in Chapter 3 (2.4 Cases that Require Configuration)
.
2.2
Starting and Exiting SETUP Utility
2.2.1
Starting SETUP Utility
Run POST following
Chapter 3 (1.1.1 POST sequence)
.
After a while, the following message will be displayed on the lower left of the screen (On-screen message
may differ from the one shown below depending on your environment).
Press <F2> SETUP, <F3> Internal Flash Memory, <F4> ROM Utility, <F12> Network
If you press the <F2> key at this time, SETUP runs and displays the
Main
menu upon completion of POST.
(You can also press <F2> key while expanding option ROM to display
Main
menu.)
Password
If you have set a password, a message prompt you to enter password will be displayed from the next time.
Enter password [ ]
You can attempt password entry up to 3 times.
If you entered a wrong password 3 times, operation stops.
(You cannot operate further.) Turn off the power.