![background image](http://html1.mh-extra.com/html/nec/n8100-1056f/n8100-1056f_user-manual_4226546097.webp)
Chapter 4
Configuring Your Server
Configuration and setup utilities are used to change your system configuration. You can configure
your system, as well as option boards you may add to your system, using the BIOS Setup Utility.
Several unique system parameters are configured using the BIOS Setup, which is stored in the
system FLASH memory.
The Adaptec Configuration Utility detects the SCSI host adapters on the system board. Use this
utility if you need to configure the two SCSI controllers in your system, to configure the hard disk
drives connected to a SCSI controller as a RAID drive, or to perform a SCSI disk format or verify
disk operation on the SCSI disk drives. The Adaptec Configuration Utility is also used to configure
any SCSI removable media devices installed in your system.
If your system has been factory configured, the BIOS Setup or Adaptec Configuration Utility do not
need to be run unless you want to change the password or security features, add certain types of
option boards or devices, or upgrade your system board.
This chapter also provides information on several system configuration parameters that are set by
jumpers on the system board. However, these parameters do not usually require change.
SYSTEM BIOS (SETUP)
The SETUP utility is used to change system configuration parameters. This utility is pre-installed in
the flash memory of the server and ready to run.
The server is configured with the correct parameters using the SETUP utility and shipped in the best
conditions. Thus, you don't need to use the SETUP utility in most cases. However, you might
wish to use the SETUP utility in the cases described below.
IMPORTANT:
The SETUP utility is intended for system administrator use only.
The SETUP utility allows you to set a password. The server is
provided with two levels of password: Supervisor and User. With
the Supervisor password, you can view and change all system
parameters of the SETUP utility. With the User password, system
parameters available for viewing and changing are limited.
Do not set any password before installing the OS.
The server contains the latest version of the SETUP utility. Dialog
boxes appear on your SETUP utility, thus, may differ from
descriptions in this manual. If you find anything unclear, see the
online help or ask your service representative.
Use the Exit menu when exiting the SETUP utility. Exiting the
utility with the POWER switch or reset operation causes the stored
parameters to lose.
Содержание N8100-1056F
