![background image](http://html1.mh-extra.com/html/nec/n8100-1056f/n8100-1056f_user-manual_4226546316.webp)
9-30 Upgrading Your Server
13.
Make sure that the heat sink is level.
NOTES:
If the heat sink is not level, remove it, and then install it again. The
following probably causes the heat sink not to be level:
– The CPU is not positioned correctly.
– All screws are not completely tightened.
Do not move the secured heat sink.
14.
Install the processor air duct.
NOTE:
Put the SCSI cable through the tunnel under the full-length
riser card receiver of the bracket. Attach the bracket while making
sure that the cable is not caught in the bracket. Also make sure that
the signal cable from the power supply unit that runs through the slit on
the left side of the bracket is not caught when attaching the bracket.
Lay the SCSI cable as shown in the figure below.
Содержание N8100-1056F
