Remote Control Features
You can use your wireless remote control to operate your MultiSync LT81/
LT100 Projector. With the remote mouse receiver connected to your computer,
you can also use the projector’s remote control to operate your computer. (See
pages 53 to 56 to connect the remote mouse receiver to your computer.)
NOTE: If you are using a Macintosh computer, you can click either the right or
left button to activate the mouse.
1 Left Click Button
Use this button to enter your menu selection. It works the same as the
"Enter" button on the cabinet.
2 Laser Pointer
Beams a laser light when “Laser” button is pressed.
3 Infrared Transmitter
Direct the remote control toward the remote sensor on the projector cabinet
or the remote mouse receiver.
4 LED
Flashes when any button is pressed.
25
MAGNIFY SLIDE VOLUME
POSITION
FREEZE
PIC-MUTE
OFF
VIDEO
MENU
LASER
R-CLICK
RGB
PC CARD
S-VIDEO
ON
POWER
+
-
+
+
+
-
-
-
4
5
6
7
8
9
10
1
3
2
5 Power On And Off
If your main power switch is turned on, you can use these buttons to turn
your MultiSync LT81/LT100 Projector on and off.
6 Video Button
Press to select an NTSC, PAL, SECAM or NTSC4.43 compatible video
source from a VCR, DVD player, laser disc player or document camera.
7 S-Video Button
Press to select an S-Video source from a VCR or other S-Video source.
8 RGB Button
Press to select a video source from a computer connected to your RGB port.
9 PC Card Button
Press to display a slide from the flash memory card inserted in the PC card
slot of your projector. (You must first install the optional LT Viewer board
into your projector.)
10 Menu Button
Use this button to call up the On-Screen Menu so you can adjust and set
the image. After you press this button, it will light up. During this time
you can use the mouse pointer and right/left click buttons to make
menu selections. If no buttons are pressed within 10 seconds the menu
turns off.
INTRODUCTION
26
