NEC LS2400, Руководство пользователя, Страница: 82 / 186

4-10 Upgrading Your System
Installing the Pentium II Processor (S.E.C. Version)
1. Power off the system and remove the left side panel as described
earlier in this chapter.
! CAUTION
Observe static precautions. Use an antistatic wrist strap. Hold
the processor only by its edges.
2. If your system has one processor and you are adding a second
processor, then you must remove the termination board in the
empty Slot 1 secondary connector. Press the tabs on the top of the
termination board bracket (A in figure) toward each other to release
them from the retention module. Lift the board bracket and the
terminator board (B) up and out of the retention module, and store it
appropriately.
Removing a Termination Board
3.
If your system has one processor and you are replacing it, leave the
termination board intact in the empty Slot 1 secondary connector.
Remove the processor you want to replace. See “Removing the
Pentium II Processor.”
4.
If your system has two processors and you are replacing one or both,
remove the appropriate one(s). See “Removing the Pentium II
Processor.”
5. Remove the new processor from its antistatic package and place it
on a grounded, static-free surface or conductive foam pad.
6.
Place the thermal pad on top of the processor so that the holes in
the thermal pad line up with the holes in the processor.
7.
Position the heat sink on top of the processor.
B
A