Configuring Your System 3-27
Resetting the CMOS NVRAM
Use the clear CMOS memory procedures, which includes the reset CMOS
NVRAM process, under "Enable F2 Prompt by Changing a Jumper and Using
SSU" in Chapter 5.
Clearing and Changing the Passwords
To clear and change the passwords:
1.
Power down your system. Remove the left side panel as described in
Chapter 4 of this User’s Guide.
2.
Move the Password Clear jumper from pins 5-6 to pins 6-7. Refer to
“Configuring System Board Jumpers” to see the location of this jumper.
3.
Power on the system and wait for POST to complete. This automatically
clears the old password.
4.
Power off the system.
5.
Move the Password Clear jumper back to pins 5-6.
6.
Replace the panel and power on the system.
7.
To specify a new password run the BIOS Setup Utility as described earlier
in this chapter.
Recovering the BIOS
This procedure should only be performed by qualified technical personnel.
CAUTION
Leave Recovery Boot jumper at factory-default setting.
This jumper should only be moved by a technically qualified
person.
Boot Block Write Protect
This procedure should only be performed by qualified technical personnel.
CAUTION
Leave boot block jumper at factory-default setting:
Programming the boot block incorrectly will prevent the
system from booting. Programming
should only be done
by
a technically qualified person. The procedure requires a
special “Boot Block Update Utility.” Contact your dealer or
sales representative for more information.
Содержание LC1400
