NEC Express5800/320Fc-LR/MR, Руководство по установке

Страница: 98 / 132

5-4 Procedures after Completion of Installation
To change the settings of the SNMP Service:
1.
Double-click [Administrative Tool] in [Control Panel].
2. Start [Services] in [Administrative Tool].
3. Select [SNMP Service] from the service list and then [Properties] in the [Action] menu.
The "SNMP Properties" dialog box appears.
4. Enter “public” in the [Community name] box in the [Traps] property sheet and click the
[Add to list] button.
IMPORTANT:

To change the community name of traps to be received from the default “*” in
the NEC ESMPRO Manager site, enter the same name as the community name
newly set in the NEC ESMPRO Manager site.

To receive trap from NEC ESMPRO Agent at the NEC ESMPRO Manager
machine, both community names should be the same.
5.
Click the [Add...] button in [Trap destinations]. After entering the IP address of the NEC
ESMPRO Manager machine of the send destination in the [Host name, IP or IPX address]
box, click the [Add] button.
IMPORTANT:
If the IP address (or host name) of the remote NEC ESMPRO Manager specified
as the trap send destination in the setup of the manager report (TCP/IP), the
message warning the duplication appears. The specification of the same NEC
ESMPRO Manager causes to be reported doubly.
6. Open the [Security] property sheet and make settings as follows;

Add the community name entered in Step 4 to [Accepted community names].

Set its authority to [READ CREATE] or [READ WRITE].

Select [Accept SNMP packets from any host.]
IMPORTANT:

If you entered any community name other than “public” in Step 4, add that
name to “Accepted community names.”

Unless you set the acceptable community’s authority to “READ CREATE” or
“READ WRITE,” you cannot perform monitoring from NEC ESMPRO
Manager.
< Setup of receiving SNMP packets from specific hosts only >
Select [Accept SNMP packets from these hosts], specify IP addresses of the hosts, IP
addresses of the servers to install Agent, and the loop-back address (127.0.0.1).
< Setup of receiving SNMP packets from specific communities only >