NEC ES1400, Руководство пользователя, Страница: 116 / 188

5-14 Problem Solving
Enable F2 Prompt by Using SSU
1.
Insert your SSU diskette in the diskette drive. This is the diskette
that is created by copying the SSU software from E
XPRESS
B
UILDER
CD-ROM that comes with the system.
2. Reboot the system by pressing Ctrl+Alt+Del while at the DOS
operating system prompt or by pressing the reset switch.
3.
When the DOS Startup menu appears, select 1 or 2 to enter the
SSU.
4. Select Step 3, “Change Configuration Settings.” If a password menu
displays, enter a user or administrative password if either is
enabled, or just press
ESC to bypass this menu prompt.
5. Select the System Board.
6.
Page down until you reach the Boot Subsystem Group. It is toward
the end of the groups.
7. Find and select the option that says, “Display ‘F2 for Setup’ Message
during POST.”
8.
Press Enter to display the option menu.
9. Select Enable and press Enter .
10. If you are finished editing the settings for the system board, press
Esc . This takes you back up to the main menu, Step 3.
11.
Press Esc again to return to the main SSU menu.
12. Select Step 4, Save Configuration. Once you select this step, the
changes are immediately saved into an INF file, a CMS file, and
nonvolatile memory.
13. Press Esc to exit the SSU. You will be prompted to reboot the system
or simply exit to the command line prompt. You’ll need to reboot the
system to let your changes take effect, but
first remove the SSU
diskette drive. Then press F10 to reboot.
You should now see the F2 prompt displayed at bootup.