NEC ELECTRA ELITE IPK II, Руководство по функциям и спецификациям

Страница: 770 / 996

Document Revision 1 Electra Elite IPK II
2 - 748 Single Line Telephones, Analog 500/2500 Sets
H
In light traffic sites, allocate one DTMF receiver for every 10 devices that use them.
H
In heavy traffic sites, allocate one DTMF receiver for every five devices that use them.
15-03-01 Single Line Telephone Basic Data Setup - SLT Signaling Type
Enter 0 if single line telephone is a 500 type (dial pulse). Enter 1 if single line telephone is a 2500
type (DTMF).
15-03-03 Single Line Telephone Basic Data Setup - Terminal Type
Enter 0 for normal 500/2500 type telephones. Enter 1 if a Voice Mail port (refer to “Voice Mail” for
more).
20-03-02 System Options for Single Line Telephones - Ignore Received DP Dial on DTMF SLT Port
Use this option to define whether the system should receive dial pulse and DTMF signals (0) or
ignore dial pulse and only accept DTMF signals (1).
20-06-01 Class of Service for Extensions
Assign a unique Class of Service for Dual OPX telephones only when using Continued Dialing.
20-13-13 Class of Service Options (Supplementary Service) - Continued Dialing
Set option to ‘0’ to prevent dual DTMF tones when using Continued Dialing.
20-15-01 Ring Cycle Setup - Normal Incoming Call on Trunk
Define the ringing cycle (1-13) for normal incoming trunk calls (DIL, ring group, etc.).
20-15-03 Ring Cycle Setup - Incoming Internal Calls
Define the ringing cycle (1-13) for ICM calls.
20-15-05 Ring Cycle Setup - DID
Define the ringing cycle (1-13) for DID calls.
80-03-01 DTMF Tone Receiver Setup
80-04-01 Call Progress Tone Detector Setup - Detect Level
If required, modify the criteria for dial tone detection and call progress tone detection for the
DTMF tones received at a single line telephone.
82-04-01 SLIU Initial Data Setup - Companding Method Type
Set various timing parameters for the analog station ETUs. The entries you make in this program
affect all SLIU ETUs installed.
82-07-01 CODEC Filter Setup for Analog Station Ports
Define the CODEC (QSLAC) Filter for each analog extension port.
Analog Ports: 1~256
Codec Filters:
0 = No Filter
1 = 0dB Loss
2 = 4dB Loss
3 = 8dB Loss
4 = Specified Data from Program 82-09