NEC ELECTRA ELITE IPK II, Руководство пользователя

Страница: 756 / 1190

Document Revision 4C Electra Elite IPK II
2 - 732 Multiple Trunk Types

80-03-01
through
80-03-08
DTMF Tone Receiver Setup

80-04-01
through
80-04-09
Call Progress Tone Detector Setup
If required, modify the criteria for dial tone detection and call progress tone detection for Tie Line
calls.

81-11-01 Tie Line Initial Setup – DP Interdigit Time Selection
Select the DP Interdigit Time (minimum pause time between Dial Pulses).
[default: 1 (Pattern B)]

81-11-02 Tie Line Initial Setup – Prepause Time Selection
Specify the loop open time for a hookflash signal sent to the Tie Line when the Recall key on a
multiline terminal is pressed. A single line telephone generates a hookflash to the Tie Line when
a single line telephone hookflash is assigned.
(default: 0)

81-11-03 Tie Line Initial Setup – Tie Line Answer Detect Time Selection
Specify the time before a Post IPK System answer (off-hook) is recognized as an answer.
[default: 4 (520 ms)]

81-11-04 Tie Line Initial Setup – Tie Line Release Detect Time Selection
Specify the before the circuit disconnect detected on the Tie Line on the distant system side is
recognized as Tie Line release.
[default: 4 (520 ms)]

81-11-05 Tie Line Initial Setup – Incoming Signal Detect Time Selection
Specify the time after the incoming signal from another system is detected before the
acknowledge signal is sent out.
[default: Wink 3(390 ms) ;Delay 3(90 ms)]

81-11-06 Tie Line Initial Setup – Loop Off-Guard Time Selection
Assign the loop off-guard time to prevent noise that could cause the system to be unable to
answer an incoming Tie Line.
[default: 4 (2.0 sec.)]

81-11-07 Tie Line Initial Setup – Length of Wink Signal Selection
Specify the time a wink pulse is sent to another system.
[default: 5 (180 ms)]

81-11-08 Tie Line Initial Setup – Length of Delay Signal Selection
Specify the time a delay pulse is sent to another system.
[default: 1 (300 ms)]

81-11-09 Tie Line Initial Setup – Incoming Interdigit Timeout Selection
Specify the time that an address signal is missing during the incoming call detection process
before an error tone is returned to the other system.
(default: 6 seconds)