NEC ELECTRA ELITE IPK II, Руководство пользователя

Страница: 113 / 1190

Electra Elite IPK II Document Revision 4C
Automatic Route Selection 2 - 89

26-01-03 Automatic Route Selection Service – ARS Misdialed Number Handling
If a user dials a number not programmed in ARS, this option determines if the system should
route over trunk group 1 (0) or play error tone (1).

26-01-06 Automatic Route Selection Service – Class of Service Match Access
With the ARS Class of Service Match Access feature, you can determine whether or not the
system should allow a call based on the COS assigned to the Dial Analysis Table (Program
26-02). This change can be used to create a tenant-like application. It then uses the trunk
group set in the Additional Entry in Program 26-02-03 to place the out-going call. When this
feature is enabled, the calls are routed in sequential order, and forward – provided the Class of
Service for the trunk groups match.
0 = Disabled (COS not compared)
1 = Enabled (COS Match Access)

26-02-01 Dial Analysis Table for ARS/LCR – Dial
Enter the digits (16 digits maximum: 1~9, 0

# , @; 400 separate entries) for the Dial Analysis
Table which is analyzed by ARS/LCR. This table is checked after any programmed F-Route
operation is completed. The system then refers to PRG 26-02-02 and PRG 26-02-03 to
determine the routing for the call. To enter a wild card/don’t care digit, press Line Key 1 to enter
an @ . Remember that the system checks the table numbers in numerical order. This means
that entries for specific numbers should be entered first (such as your local area codes), then
enter the items containing wild card digits. If the system sees an entry of 2@@ any table entry
which follows is ignored.
For example, if 268, 269, and 270 are local exchanges, these would be the first three table
entries which route according to the settings made in Program 26-02-02 and Program 26-02-03
for each of the table entries. If the next entry is 2@@, the system checks no further in this
program and routes all other 2xx numbers according to the entries made in PRG 26-02-02 and
PRG 26-02-03 for this table entry.

26-02-02 Dial Analysis Table for ARS – ARS Service Type
For each Dial Analysis Table (1~200), select 0 for no ARS, 1 for Service Type 1 – Route to Trunk
Group Number to have the number route to a trunk group [Refer to Program 26-02-03] or 2 for
Service Type 2 – F-Route Selected to have the dialed number controlled by the F-Route table. If
Service Type 2 is selected and F-Route operation is on, the F-Route table used is determined by
Program 44-04. If F-Route operation is off, the routing is determined by Program 44-05.

26-02-03 Dial Analysis Table for ARS – Additional Data/Service Number
For each Dial Analysis Table (1~200), if Service Type 1 was selected in Program 26-02-02,
enter the trunk group number (0~100, 0 = No Route).

26-02-04 Dial Analysis Table for ARS – ARS Class of Service
For each Dial Analysis Table (1~200), set the Automatic Route Selection (ARS) Class of Service
(0~16).

26-02-05 Dial Analysis Table for ARS – Dial Treatment for ARS
For each Dial Analysis Table (1~200), set the Automatic Route Selection (ARS) Dial Treatment
(0~15) to be used.