NEC Aspire, Руководство пользователя, Страница: 90 / 262

Section 3: Features
82 Product Description
● Caller ID Edit Mode (Program 20-19-03) must be enabled.
● The maximum number of Caller ID digit is 20. If the total number of digits (trunk access code
(Program 10-02-05) and Caller ID) is over 20, the remaining Caller ID digits are not dialed.
For example:
Trunk Access Code (Program 10-02-05): 123456#* (8 digits)
Incoming Caller ID: 12345678901234567890 (20 digits)
Aspire Wireless Dials: 123456#*123456789012
Caller ID Sender Queuing Added
The Aspire system can provide Caller ID (calling party number) to a single line telephone which
has a display.
With older software, if all Caller ID sender resources were busy in the system, the call would ring
the SLT without any Caller ID information displayed. With this enhancement, the system can queue
the incoming call to the single line telephone if the system Caller ID sender resources are busy.
With this option, Program 20-19-05 is added.
While an incoming call is waiting in queue, if the SLT user lifts their handset, they will hear silence
(no dial tone) and can not dial out. When the SLT user goes back on hook, the system immediately
sends the queued call to the SLT without Caller ID.
Option Available for FSK or DTMF Type for SLT
An option (Program 15-03-11) is available for the Caller ID which allows you to select either FSK
or DTMF as the Caller ID type to be received by a single line telephone.
Option Available for FSK or DTMF Type from Analog Trunk
An option (Program 14-02-16) is available for the Caller ID which allows you to select the type of
Caller ID signal from an analog trunk - FSK or DTMF.
Name and Number Limited Display with DSTU PCB
The Caller ID feature has been enhanced to provide better functionality with the i-Series telephones
when using a DSTU PCB.
Previously with the i-Series telephones, the Caller ID name was limited to the 10 left most charac-
ters and the Caller ID number was limited to 9 digits as both were included on the second line of the
display.
Example:
With software 4.0E or higher, the name and number will each appear on a separate line, allowing
for a maximum of 20 characters/digits per line.
● When there are more than 20 characters set in Program 20-20 : Message Setup for Non-Caller
ID Data, either the
Þ rst or last character(s) will be missing (based on the entry in Program 20-
19-01).
● This feature option is available for i-Series telephones only - Aspire telephones will not follow
the setting in Program 20-02-15.
● The display of both Caller ID number and name is shown only while the call is ringing.
● The CO name/DID name is not displayed during ringing if Program 20-02-15 is set to "1" or
’2".
● If Program 20-09-06 : Class of Service Options (Incoming Call Service ) : Incoming Time
Information Display is set to "1" (call time displayed), the
Þ rst line will display the time and
date.
L i n e 0 0 1
N E C - I n f r o n 2 0 3 9 2 6 5 4 -