The connection method differs depending on the type of computer the monitor is
connected to.
Refer to the following page to connect the monitor.
When other types of computers are used, refer to their operation manual for the correct
connection procedures.
Signal cable Connection
Connections
Always turn off the power supply of the computer and the
monitor before performing the connection procedures.
Connection Preparation
Cable storage compartment cover
Connect the signal cable and electrical cord
and then store the cable section that is not
used in this compartment.
Refer to the following figure in advance and remove
the cover of the cable storage compartment.
(Remove the cover while pressing the parts indicated
by the
e
and
f
arrow marks in the figure.)
Use the accessory signal cable and the adapter for the
Macintosh. Connect the cable as shown in the figure. When
another video card is used, read the operation manual for
that card.
Connect the Macintosh
adapter to the computer
video output connector.
Connect the signal
connector to the
Macintosh adapter.
Connect the standard connector to the video input
connector on the rear side of the monitor.
Place the signal cable to the hook on the rear side
of the monitor.
Connect the standard connector to the video
output connector of the computer.
Connection method will differ in accordance with the computer in use. Connect one end of
the supplied signal cable to the mini D-SUB 15-pin connector on the rear of the unit, and
then connect the other end to the computer’s video connector. Refer to the following if
connection is to be made to any other computer, refer to the instruction manual of the
machine in question.
■
To an IBM PC or Compatible
Tighten the screws on the connector or
adapter securely.
I - 7
■
To a Macintosh
Macintosh
adapter
(not included)
Tighten the screws securing the plug tightly
to prevent it from becoming disconnected.
Tighten the screws securing the plug tightly
to prevent it from becoming disconnected.
