Neat NEO IP/GSM, Техническое руководство

Страница: 22 / 56

NEO IP/GSM Technical Handbook
Document number: NE41 09002-02 v2.0
3.6 Before calling
3.6.1 Pre-call signal
It is possible to have a signal sounding before the home care phone makes the
call to the alarm central. This only applies to
User alarms
.
During this period it is possible to interrupt the alarm if it was activated by mis -
take. The user will also always be aware of that NEO IP/GSM is calling.
To set the parameters for dialling in speaker, pre-call signal, see 8.10.2 Indications
on page 44.
3.7 Calling
This is how long the home care phone should wait for an answer.
To set the time to wait for answer, see 8.11.1 Outgoing call on page 45.
3.8 Protocols
The home care phone NEO IP/GSM can communicate with number of different
protocols, where some of the most common are:
• NEAT TALK
• CPC
• Tunstall
• Home phone (call to normal telephone)
For a full list of supported protocols, see Appendix A Technical data on page 54.
The protocols contain a lot of details and information. Please refer to related
documents for specification of each protocol.
However when the home care phone is configured to call to a normal telephone,
NEO IP/GSM must use the Home phone protocol. To control the conversation in
the Home phone protocol, the alarm receiving party can press the buttons on the
telephone. The meaning of each button is shown below.
Command Meaning
1
or
3
Go into simplex mode, change speech direction
2
Go into duplex mode
4
Receive phone ID, go into duplex mode
5
Toggle speaker level and microphone sensitivity
0
or
6
Disconnect the call
7
Go into simplex mode, activate the microphone
8
Go into simplex mode, activate the speaker
The alarm call
22 of 56