NCR S26, Руководство пользователя, Страница: 101 / 220

Using the EISA Configuration Utility
NCR S26 Hot Plug Server User Guide 5-11
4. Select “Step 4: Examine switches or print report,” and press Enter to
display the screen as shown in the figure below.
Figure 5-5. Examine Switches or Print Report
Step 4: Examine switches or print report
You must PHYSICALLY verify that the switches and jumpers
of each board marked with an arrow (
) are set as required.
These switches cannot be detected or changed by this
program.
To view the required settings for the highlighted board,
press ENTER. Pick up the board and compare its
settings to the required settings. Change the board
settings to match the required settings.
System
EISA 1
EISA 2
EISA 3
PCI 1
PCI 2
PCI 3
PCI 4
PCI 5
Embedded PCI SCSI Controller
Embedded PCI VGA Controller
NCR 3426 Dual Pentium System
(Empty)
(Empty)
(Empty)
(Empty)
(Empty)
(Empty)
(Empty)
(Empty)
View = ENTER <Print = F7> <Done = F10>
5. Notice the boards marked with an arrow on the screen, if any. The arrow
indicates that the boards in your computer may have defined jumpers and
switches that you must physically verify. It may also mean that there is a
software statement with additional information about the board.
6. To view the switch and jumper settings, highlight the board marked with
an arrow and press Enter. The switch/jumpers settings screen for the
board displays.
7. Scroll through the switch and jumper settings for the board, and press F10
when you have finished viewing the information.