NCR RealScan 7802, Руководство пользователя

Страница: 56 / 94

NCR RealScan 7802 Price Verifier User Guide
06/03 497-0425530 Release E 56 of 94
Note: If the scanner did not beep 8 times, scan the following sequence of
programming tags.
•
Hex 3 , Hex 0 , Hex 8 – 7802 defaults.
•
Hex 1 , Hex 6 , Hex 2 – Remove Label Identifiers.
•
Hex 1 , Hex 4 , Hex C , Hex 1 – Enable Code 39 Full ASCII (required is scanning
Code 39 characters other than the standard Code 39 set: A-Z, 0-9, $, /, +, %,
space)
•
Save and Reset
3.
Scan the specific labels (listed in the following table) required to change the
configuration to your network’s parameters. Each setup label beeps once when
scanned correctly. The RealScan 7802 displays the raw code, then the setup name
and entered value. Frequently used barcodes are provided as a .PDF file on the
CD-ROM and may be printed and used directly from the page.
4.
When all the setup labels have been scanned in and visually verified, scan the Save
Configuration label. This causes the complete configuration setup to be written to
the RealScan 7802 non-volatile memory and reboot so the changes can take effect.
5.
At this point restore the scanner programming.
•
Remove power from the RealScan 7802, then apply power again.
•
Scan the Default tag, then any other programming sequence desired.
If you do not want to scan the Default tag, scan the following sequence of
programming tags.
•
Programming Mode – Puts scanner in Programming Mode State
•
Hex 1 , Hex 6 , Hex 0 – Include Label Identifiers.
•
Hex 1 , Hex 4 , Hex C , Hex 0 – Remove Full ASCII (if Full ASCII is required by
the customer, do not scan these four programming tags).
•
Make any other programming changes needed.
•
Save and Reset
6.
This completes the network configuration for the RealScan 7802. If your network
servers have already been set up, the RealScan 7802 starts communication with the
network normally.