NCR 74 OFX (7874), Руководство пользователя

Страница: 105 / 268

Chapter 4: Operation 4-13
Note:
If 0.000 kg (0.00 lb) is not displayed, reset the scale by pressing the Scale
Zero button. If this does not work, turn the scanner circuit breaker OFF and then
ON .
2. Pick up the item and place it in the center of the Top Plate.
Note:
Make sure the item does not overhang. Whatever is weighed must fit fully
on the Top Plate.
3. Press the “weight request key” (for example, “4 0 1 1 [PLU]”) on the terminal. The
weight is communicated to the terminal.
The following are possible responses after weighing an item:
•
If enabled through programming, a Good Tone is emitted to indicate transmission
of a stable, non–zero weight.
•
If a bad weigh occurs, weigh the package again (Refer to Step 2.)
•
If the Light Bar displays an error code, remove the item from the Top Plate. Then
remove the Top Plate and check for debris under it. If there is debris, clean it.
Replace the Top Plate, and then press the Scale Zero button to reset the scale.
•
Wait for the 0.000 kg (0.00 lb) message to be displayed. When it is displayed, weigh
the item again.
Note: If the Light Bar still displays an error code, contact a supervisor, the Service
Company, or NCR Customer Services.
Sensormatic® Security Tag Deactivation Procedure
Normal Operation
The operating procedures can vary according to the parameter settings. The following
procedure assumes the Sensormatic® parameters are set to the following values.
•
Security tag deactivation function is enabled
•
Security tag deactivated tone is enabled
•
Security tag detected tone is enabled
Following this procedure assumes the RealScan 74 and the Sensormatic® AMB9010
Controller are turned on and functioning properly.
1. Pass an item across the scanner.
Note: As the bar code goes through the scan zone, the RealScan 74 reads it.