21
5
Securing the Base to the Mounting Bracket
To attach Explora to the bracket:
1. Align the tabs on the bracket
with the slots on the bottom of
the unit.
2. Insert the tabs into the slots and
at the same time, gently push
down on the unit.
The side of the base should rest
on the two angle tabs protrud-
ing from the bracket, shown in
the diagram.
Using the Security Device
To use the security device with the
mounting bracket, do the following:
1. Before attaching the base to the
bracket, make sure you remove
the security cover from the side
of the terminal. If you have not
done this, go back to step one in
“Installing the Security Device”
and remove the security cover.
2. Attach the base to the mounting
bracket, using the steps above.
Then return here to step 3.
3. Push the small part of the secu-
rity device through the hole in
the angle tab on bracket and
through the security cover slot,
so that the center hole of the
device aligns with the threads
on the inside of the chassis.
4. Insert the pan-head screw
(M2.5, supplied) through the
center of the security device,
and screw it all the way in, until
it is secure.
5. To lock the unit to the bracket,
insert a lock or security cable
through the hole in the large
area of the security device.
Security device and
screw
Side of unit resting
on angle tabs
Align tabs and slots
M2.5
Pan-Head
Screw
Lock
