15
5
Reassembling the Base
To reassemble the base, follow these steps:
1. Swing the front of the top
cover over the front edge of
the bottom section and con-
tinue down with the rest of
the top cover unit it covers the
bottom section (this is a tight
fit). There should be a one-half
(1/2) inch gap between the
bottom section back, and the
top cover back.
Note
Make sure the top cover is
resting completely flat on
the bottom section before
doing step 2.
2. Hold the back of the bottom
section and push the top cover
toward the back until the two
tabs click through the two
openings on the bottom
section.
3. Once the top cover and
bottom section are together as
a unit (base), turn it upside
down, so that the base bottom
is facing up and the front is
facing you.
4. Secure the base together by
screwing in the two phillips
screws into the two holes
located at the front corners on
the bottom.
5. Tighten the screws so they are
snug, but do not over tighten.
6. Turn the base upright and
refer to Section 3, to install the
cabling.
7. After the system is installed,
perform the memory test, pre-
sented next.
1/2 Inch
Gap
Side View
Bottom of Base
Insert
Screws
Tabs
Hold
Here
Push
Here
