NBB Planar-D1, Руководство по эксплуатации

Страница: 38 / 66

38
Planar
®
-D1 / Compact-M2 R7
SW3
SW5
SW7
SW9
SW2
SW4
SW6
SW8
SW10
SW1
SW11
1
2
3 4
5
6
7
8
Technical documents
Change code
> Change the receiver code
If you need to change the code of a transmitter this is possible via the push buttons.
Your NBB receiver does not need to be dismantled or opened up. Proceed with your
transmitter as described in the following steps – within a few minutes your system is
ready for operation again.
1. Turn off your transmitter to activate changing of the code.
2. Push SW1 + SW2 + SW3 + SW4 amd hold for 5 seconds.
3. The 7-segment functional display will show “I” “n” “t” “e” “r” . The set code number
will be shown.
4. By pushing SW1 (for a lower code) or SW2 (for a higher code) the code can be changed.
5. Ba pushing SW9 (ON/HORN) the new code will be set.
6. Once prgramming is complete the transmitter will automatically be switched off. Your
system is now ready for operation.
2
1
3
5
4
Transmitter off
SW 1+ SW 2 + SW 3+ SW 4
press and hold 5 sec.
„I“ „n“ „t“ „E“„r“, actual
code number starts flashing.
SW 2 (for a higher code)
Save the actual code number
4 SW 1 (for a lower code)