NAX 3000S, Руководство пользователя

Страница: 18 / 32

18
components for assembly are included in the packaging. This operation manual applies to various models of mowers.
The mower described may differ from your purchase. Read the passages that refer to the device model you have.
CONSTRUCTION OF PETROL MOWER
Illustrative drawings can be found on page 4, Fig. 1-2
1 Handle
2 Engine brake lever
3 Drive lever with line
4 Clamp lever
5 Starter handle with cable
6 Starter cable attachment point
7 Basket
8 Rear wheel
9 Handle connection nut with housing
10 Water cleaning system connection
11 Front wheel
12 Air filter cover
13 Engine
14 Fuel-filler cap
15 Oil filler cap
16 Muffler
17 Spark plug pipe
18 Side discharge cover
19 Wheel lock lever
20 Side discharge chute
21 Basket full indicator
22 Cable adjustment
23 Grass ejection cover
24 Cutting height adjustment lever
25 Side comb for laying grass
ASSEMBLY
The mower handle is factory set in the storage position.

Set the lower handle to the use position, making sure that the handle is between the stops and tighten it with the
wing nut.

Set the upper handle to the use position and lock it with the clamping lever. Turning the nut changes the length
of the clamping lever bolt, thus increasing or reducing the clamping force. Fastening occurs when the clamp is
pressed against the handle in the direction of the arrow on
Fig. 3.
Attention! Too short the bolt with a nut may cause the clamping lever not to be tightened, and
consequently damage the lever.
Attention! When unfolding and folding the handle, make sure that the engine brake cable does not break
or bend. A bent or otherwise damaged cord may prevent the mower from working properly.

Fasten the starter rope handle 5 (Fig. 2) at the attachment point 6 (Fig. 2) .
Attention! The starter rope extends with resistance. Pull the engine brake lever towards you and slowly
pull the cable out to the necessary length. Remember that pulling the starter cord vigorously can start the
mower
.
FILLING THE ENGINE WITH OIL
The engine is not filled with oil at the factory. There may be traces of oil remnants in the engine after factory inspection.
Before first start-up, pour approximately 0.47L of recommended B&S SAE30 engine oil, checking its level on the dipstick
integrated with the oil filler cap Fig.4 .