Navman Qube 300, Руководство по установке

Страница: 10 / 18

Qube 300 | Installation Manual
10
2 White +3.8V DC Reference for Analogue Input
3 Yellow Multi I/O-1 Digital Input OR Digital Output OR Analogue Input 1
(Also Wake from Sleep)
4 Green Multi I/O-2 Digital Input OR Digital Output OR Analogue Input 2
5 Light Blue/Black RXD-2 RS232 Serial Port 2 Data Input
6 Light Blue TXD-2 RS232 Serial Port 2 Data Output
7 Orange 1 W+ Temperature Probe Power Supply
8 Orange/White 1 WD Temperature Probe Data
10-Way Expansion Connector:
Pin Wire Colour Function Description
1 Black GND Ground Output
2 Brown TXD-3 RS232 Serial Port 3 Data Output
3 Brown/White RXD-3 RS232 Serial Port 3 Data Input
4 Black GND Ground Output
5 Purple DI-4 Digital Input 4 (Active High/Low) (Wake from Sleep and
RPM Count)
6 Blue DI-3 Digital Input 3 (Active High/Low) (Wake from Sleep)
7 Blue/White DI-2 Digital Input 2 (Active High/Low) (Wake from Sleep)
8 Green/White DI-1 Digital Input 1 (Active High/Low) (Wake from Sleep)
9 Light Green DO-1 Digital Output 1 (Active Low only)
10 Grey DO-2 Digital Output 2 (Active Low only)
Wake from sleep configuration
Wake from sleep can be triggered on MIO-1 Active HIGH ONLY and on DI-1 thru DI-4 in either an Active
HIGH or Active LOW configuration.
When the event is triggered the Qube300 will fully boot up, send any sensor events triggered and after 5
mins return to sleep mode.
Note: If a senor input line is configured for read with ignition on only, Qube300 will boot up but not send
sensor events.