Qube 300 | Installation Manual
13
4.5
Install the Security Cover
IMPORTANT NOTICE
You cannot plug or unplug any cables after the tamper-proof security cover has been installed. To change
cable configuration, tamper-proof security cover must be removed.
When all the wiring is complete, you must install the tamper-proof security cover. This has an upper part
and a lower part.
Slide the lower part under the cables and push into place onto the lower front part of the Qube 300. The
screw pillar should align with the screw hole in the Qube 300.
Fit the cables for your wiring configuration into the appropriate slots on the lower part, as shown:
Angle the upper part of the security cover onto the front of the Qube 300 then push it down into place. The
upper and lower parts of the security cover should fit snugly together with no gap between them. The two
screw holes at the sides of the Qube 300 should align with the two screw pillars at the sides of the security
cover.
Working from underneath the Qube 300, insert the three security screws into the three screw pillars and
screw into place. Tighten using a Torx T10 security screwdriver.
The example on the front cover shows a completed Qube 300 installation with all cable options connected.
4.6
Mount the Qube 300
Mount the Qube 300 securely at your chosen installation location using the four self-tapping screws provided
or cable ties. Place these through the slots along both sides of the Qube 300.
The upper part has three plastic slot covers that can be broken out to match your wiring configuration:
10
-
W
ire
I
/
O
cable
MDT/M
-
Nav
or
S
erial RS232
cable
3
-
W
ire
P
ower
cable
GPS
Antenna
cable
Cellular
Antenna
cable
8
-
Wire
I/O
cable
Break out ONLY
for
an
8
-
W
ire
I
/
O cable
.
Break out ONLY
for
an
MDT/M
-
Nav
or
Serial RS232
cable
.
Break out ONLY
for
a
10
-
W
ire
I
/
O cable
.
Содержание Qube 300
Страница 1: ...Qube 300 Installation Manual ...
Страница 15: ...Qube 300 Installation Manual 6 Dimensions ...
Страница 18: ...Qube 300 Installation Manual ...