![background image](http://html1.mh-extra.com/html/navman/g-pilot-3380/g-pilot-3380_operation-manual_3610280012.webp)
G-PILOT 3380 and Operation Manual
NAVMAN
13
3-1-1 AUTO key
Press to engage
AUTO
mode. The G-PILOT is
now steering the boat based on the selected
steering mode. Press and hold for 2 seconds to
engage
H-STEER
mode.
3-1-2 STBY key
Press to disengage
AUTO
mode and set
STBY
mode. The G-PILOT is not steering the boat
– the helmsman must steer the boat using the
manual helm.
3-1-3 Dodge keys
Press
or
to trigger an immediate
dodge to port or starboard. Repeated presses
of the same key increments dodge angle.
STBY
mode: Jogs the rudder left or right
while the key is pressed
AUTO
mode: Activates a dodge. Causes
the vessel to deviate from the set course by a
preset angle.
3-1-4 Turn key
Press to display the turn menu. The boat
follows a preprogrammed turn sequence.
Select an item from the menu then press
or
to activate the turn in the
corresponding direction.
Tip:
Repeated pressing
will cycle through
the menu selection.
3-1-5 MODE key
Press to select steering mode.
Tip:
Repeated pressing
will cycle through
the menu selection.
3-1-6 Control Dial
When using menus and adjusting settings,
use to scroll through items and increment or
decrement values.
STBY
mode: Moves the rudder to port or to
starboard half of a degree per click.
AUTO
mode: Changes the set course by one
degree per click.
Note:
In GPS mode, the set course can not be
adjusted as the course is controlled by the
navigation instrument.
3-1-7 ESC key
When using menus and adjusting settings,
press to step back one level without saving
changes.
When no menus or settings are displayed, press
to jump back to the most recently used G-PILOT
display screen.
3-1-8 ENT key
When using menus and adjusting settings,
press to choose selection or save setting.
Tip:
When showing the Basic, G-PILOT or
Compass screen, pressing
opens the
Parameters menu.
3-1-9 MENU key
Press to show the Options menu (where
applicable).
Press twice to show the Setup menu.
3-1-10 DISP key
Shows the Display menu.
Tip:
Repeated pressing
will cycle through
the menu selection and will automatically
select the highlighted entry after 1 second.
3-2
Turning the G-PILOT 3380 on
• Press
.
• If there are no other G-PILOT display heads
on the system, The G-PILOT 3380 will turn
on and enter
STBY
(Standby) mode.
Note:
If the G-PILOT was switched off while
still in
AUTO
mode, a warning message will be
displayed to alert the user that there may have
been a power interruption.
Note:
When the G-PILOT is powered on, the
Control Dial and Dodge keys are active and
can operate the rudder at any time (see Power
Steering modes 1-1-3)