Version 08.08.2022
HW: 16 (V65)
VL1-TOM
P
a
g
e
15
2.7.
After-market rear-view camera
Note: Do not forget to set dip5 of video-interface to ON before testing.
To switch to the rear-view camera when reverse gear is engaged, an external switching
signal from the reverse gear light is required. As the reverse gear light signal contains
electronic interference, a traditional open relay (e.g AC-RW-1230 with wiring AC-RS5) or
filter (e.g. AC-PNF-RVC) is required. Below schema shows the use of a relay (normally open).
Connect the green
switching input cable
to the output connector (87) of the relay.
Connect the Reverse light’s power-cable to coil (85) and the vehicle’s ground to coil
(86) of the relay.
Connect the output connector (87) of the relay to the rear-view camera’s power-
cable, like you did it to the green
switching input cable
before.
Connect stabile and per12V to the relay’s input connector (30).
Содержание VL1-TOM
Страница 7: ...Version 08 08 2022 HW 16 V65 VL1 TOM Page 7 2 2 Connection schema...
Страница 9: ...Version 08 08 2022 HW 16 V65 VL1 TOM Page 9 2 4 Installation daughter PCB...
Страница 10: ...Version 08 08 2022 HW 16 V65 VL1 TOM Page 10...
Страница 11: ...Version 08 08 2022 HW 16 V65 VL1 TOM Page 11...