Optotune 6X System
Setup Guide
Created By: John Dong
Rev A
Reviewed By:
Date: 9/6/2019
Page 5 of 7
This document contains information proprietary and confidential to Navitar, Inc. Any disclosure, use or duplication of this document or any of the information contained
therein for other than the specific purpose for which it was disclosed is expressly prohibited except as Navitar, Inc. may otherwise agree to in writing.
4.
Waypoints
: Save Optical Power as waypoints to remember or quickly switch between multiple Optical Power
settings. You can also start a loop where the Optical Power will automatically iterate through each saved setting
for the number of cycles specified, with a specified delay between iterations.
a.
Press Add to save current Optical Power setting as a waypoint.
b.
Press Go to set Optical Power to waypoint.
c.
Set Num Cycles to set the number of cycles you wish to run during the loop. Set to 0 to run cycles
indefinitely.
d.
Set Delay to specify the amount of time in milliseconds to wait between iterations.
e.
Press Start to begin cycling through each waypoint, press Stop to stop the loop.
3.5
Z
OOM
C
ONTROL
5.
1.
Zoom
: Controls the motorized zoom of the lens. Increasing Zoom will increase the magnification. Lighting may
need to be adjusted after changing Zoom as the image may dim.
a.
Drag the slider and or use the numeric control box to manually adjust the Zoom.
b.
The Min and Max buttons will bring the Zoom to its Min and Max limits.
c.
Hold the fine and fast jog buttons to jog the Zoom in the corresponding direction.
d.
Press Stop to abort the current movement of the Zoom motor.
2.
Waypoints:
Save Zoom as waypoints to remember or quickly switch between multiple Zoom settings. You can
also start a loop where the Zoom will automatically iterate through each saved setting for the number of cycles
specified, with a specified delay between iterations.
1
2
3
