Navistar MaxxForce 10, Руководство по эксплуатации и обслуживанию

Страница: 91 / 102

SECTION 5 – MAINTENANCE SCHEDULE AND SERVICE PROCEDURES
5. Install and tighten the coolant tank cap until the plastic cap
clicks or the metal cap runs up against the detent.
CRANKCASE PRESSURE
Service Interval: 180,000 - 200,000 miles (290,000 - 322,000
km) or 6,700 - 7,500 hours
• For inspection procedures, see theapplicable Engine
Diagnostic Manual .
• Have an authorized service provider measure the
crankcase pressure at the correct service interval.
TURBOCHARGERS
Service Interval: 180,000 - 200,000 miles (290,000 - 322,000
km) or 6,700 - 7,500 hours
1. Clean, then remove the turbocharger compressor inlet
connections for both turbochargers.
2. Inspect the compressor wheels for the following:
• Dirt or corrosion
• Wheel rub damage
• Wheel blade damage (bent or broken tips)
3. Check condition of turbochargers. (Consult with an
authorized service provide if questionable.)
CLEANING DIESEL PARTICULATE FILTER
For Engine Using CJ-4 Engine Oil
Service Interval: 200,000 miles (322,000 km) 30 months or
6,000 hours
Clean DPF at designated service interval. The ECM will
illuminate the MIL and generate an Ash Servicing Required
message on the integral digital display at or if necessary before
the specified interval. Take vehicle to your Navistar certified
dealer for cleaning.
For Engines Using CI-4 Engine Oil
Service Interval: 150,000 miles (241,000 km) 22 months or
4,500 hours
Clean DPF at designated service interval. Take vehicle to an
authorized service provider for cleaning.
SERVICE COOLING SYSTEM
Service Interval for Extended Life Coolant: 300,000 miles
(500,000 km) or 12,000 hours
WARNING
To prevent personal injury or death, shift
transmission to park or neutral, set parking
brake, and install wheel chocks before doing
diagnostic or service procedures.
Page 83