6
Part Replacement
Replacing the Console Assembly
!
To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug the power cord from the wall outlet and the
machine and wait 5 minutes before cleaning, maintaining or repairing the machine. Place the power cord in a secure location.
Tools Required: #2 Phillips Screwdriver
1. Using a #2 Phillips screwdriver, remove the 4 indicated
screws from the Console Assembly.
2. Gently lift the Console Assembly and disconnect the
Console Cable and the Heart Rate Cable.
Note:
Do not crimp the cables. Do not allow the cables to
fall down the Console Mast. Use a rubber band or wire tie.
3. Installation is the reverse procedure.
4. Dispose of the old parts.
5. Inspect your machine to ensure that all hardware is tight and components are properly assembled.
Do not use until the machine has been fully assembled and inspected for correct performance in accordance with the Owner’s Manual.
6. Initial Setup of the Console
During the first power-up, the Console must be setup for your preferred measurement units, the machine type, and brightness of the screen.
a.
Units of Measurement: Push the Increase/Decrease buttons to change between “Miles-Lb” (Imperial English) or “Km-Kg” (metric).
b.
Push START/ENTER to set.
c.
Machine Type: Push the Increase/Decrease buttons to change between “BIKE” and “ELLIPTICAL”.
d.
Push START/ENTER to set.
e.
Backlight: Push the Increase/Decrease buttons to change the screen contrast, with “1” the lowest and “5” the highest.
f.
Push START/ENTER to set. The Console goes back to the Power-Up / Idle Mode screen.
Note:
To change these choices, consult the “Console Set-Up Mode” section.
#2
*
X4
Содержание Schwinn 450
Страница 23: ...23 ...
