Nautilus NS-700, Инструкция по сборке, Страница: 13 / 25

NS-700
12
A. Remove the Ball, Washer, and U-Bracket from one side of Cable #2 (70).
B. Route Cable #2 (70) through the Pulleys in the left Swivel Arm as
shown. Continue to route Cable around the two pulleys connected
to the Rear Base Frame and then around the pulleys located in
the Rear Top Frame as shown.
C. Loop Cable #2 (70) around a 4 1/2” Pulley (58) and attach pulley
to the Top Weight Pulley Housing (63) using the hardware shown
in detail A. Tighten hardware securely. Attach the Top Weight
Pulley Housing (63) to the Selector Rod/Top Weight Assembly
(52 & 53). Do not tighten hardware.
D. Loop Cable #2 (70) over a 4 1/2” Pulley (58) and attach pulley to
the Rear Top Frame using the hardware shown. Loop cable
around a 4 1/2” Pulley (58) and attach pulley to the Rear Top
Frame using the Cable Retaining Bracket (62) and the hardware
shown. Tighten hardware securely.
E. Route Cable #2 (70) through the top tube of the Rear Top Frame
making sure that the cable is above the bolts. Loop Cable around
a 4 1/2” Pulley (58) and attach pulley using the hardware shown in
detail B. Tighten hardware securely.
F. Route Cable #2 (70) around the pulley located on the Hi/Low
Pulley Adjuster and continue to route cable through the pulleys in
the right swivel arm as shown.
G. Re-Install the Ball, Washer, and U-bracket to Cable #2 (70).
step
9
Step #9 Materials:
# Component Qty
58 4 1/2" Pulley 4
62 Cable Retaining Bracket 1
70 Cable #2 - High/Low Pulley Cable
356"L
1
79 Hex Bolt - 3/8" x 3"L 1
82 Hex Bolt - 3/8" x 2"L 2
84 Hex Bolt - 3/8" x 1 1/2"L
with thread lock
1
95 3/8" Flat Washer 7
97 3/8" Lock Nut 3
101 Pulley Spacer 1/2"L 2