Nautilus Be strong NS 700X, Инструкция по сборке

Страница: 19 / 26

1
Nautilus NS700X
NS700X Press Arm
# component Qty
58 4 1/2” Pulley 5
72 Cable #4 - Secondary Cable 179.5”L 1
77 Hex Bolt - 3/8” x 3 1/2”L 1
81 Hex Bolt - 3/8” x 2 1/4”L 1
82 Hex Bolt - 3/8” x 2”L 4
83 Hex Bolt - 3/8” x 1 3/4”L 1
95 3/8” Flat Washer 14
97 3/8” Lock Nut 7
101 Pulley Spacer 1/2”L 2
Step 11 Components: Procedure:
ASSEmBLY
STEP 11
a. Attach the looped end of Cable #4 (72) to the side of the Rear Upright (5) using the hardware
shown in Detail A. Tighten hardware securely, but do not overtighten.
B. Loop Cable #4 (72) around a 4 1/2” Pulley (58) and attach the pulley to the lever bracket on the Leg
Extension Frame (8) using the hardware shown. Tighten hardware securely.
c. Loop Cable #4 (72) around a 4 1/2” Pulley (58) and attach the pulley to the lower bracket on the
Rear Upright (5) using the hardware shown. Proceed by looping the cable around a 4 1/2”
pulley (58) and attaching the pulley to the bracket on the Rear Base Frame (1) using the hardware
shown. Tighten hardware securely.
D. Loop Cable #4 (72) around a 4 1/2” Pulley (58) and attach it to the lower hole in the Double
Floating Pulley (61) using the hardware shown. Proceed by looping the cable around a 4 1/2”
Pulley (58) and attach the pulley to the angled bracket on the Rear Base Frame (1) using the
hardware shown. Tighten hardware securely.
e. Attach the looped end of Cable #4 (72) to the bracket on the Rear Upright (5) using the hardware
shown. Tighten hardware firmly, but do not overtighten. NOTE: This cable termination can be
used for exercise attachments such as the leg press. If an attachment is installed, attach the
looped end of the Cable #4 (72) to the coupling on the attachment cable. Please refer to
attachment instructions for more details.