Nautilus® Commercial Series Bike Assembly Manual
Step 1:
Locate the following for this step:
Parts:
• Console Mast (B)
• Seat Assembly (D)
Hardware:
• Ref #1 Allen Head Bolt M10x25 Qty. 4
• Ref #2 Spring Washer M10 Qty. 4
• Ref #3 Flat Washer M10 Qty. 4
Tools:
• 8mm Allen Wrench
1-1 Connect the attached long Wire Tie (L) to the
main and TV cables (M) and use it to pull the
cables up through the Mast (B). Discard the
Wire Tie after use.
1-2 Align the Mast (B) with the four holes in the Main
Frame. (N)
1-3 Install and completely tighten the hardware.
1-4 Insert the Seat Assembly into the Main Frame.
Pull up on the Adjustment Lever (J) to allow the
locking pin to to clear the Main Frame and
release the Adjustment Lever when the seat is
at the desired height.
*Note:
Make sure that the plastic seat sliders inside
the seat tube are in the correct position to
prevent any damage. If the seat slider plastic
tabs have fallen out of slots at the bottom of
the seat post, carefully push the seat slider
plastic back into holes prior to seat
installation.
The following instructions provide direction in assembling the base unit for the Nautilus® Commercial Series Bike model
U916. All instructions in the manual are given with the orientation of sitting on the bike facing the console. The console is
the front, while the seat is the back.
assembly guide
Figure 1:
B
L
M
N
1
2
3
D
J