BATHROOM FAN – THEIA 70 CFM WITH 1 LIGHT
2
List of parts and accessories supplied
PART NAME
APPEARANCE
QUANTITY
PART NAME
APPEARANCE
QUANTITY
Fan body
1
Long wood
screw (BB)
4
Grid /
Light cover
1
13 W, GU24
Lightbulb
1
WARNING
Before beginning assembly of product, make sure ail parts are present. Compare parts with package contents list and hardware contents list.
If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 30 minutes
1. Always disconnect the power supply prior to servicing the fan,
motor or junction box.
2. Installation work must be carried out by a qualified person(s) in
accordance to ail local and safety codes including the rules for
fire-rated construction.
3. Follow ail local building, safety and electrical codes as weil as
NEC (National Electrical Code) and OSHA (Occupational Safety and
Health Act).
4. Electric Service supply must be 120 volts, 60 hertz.
5. This unit must be properly grounded.
6. Do not bend or kink the power wires.
7. Exercise care to not damage existing wiring when cutting or
drilling into walls or ceilings.
8. Sufficient air supply is required for proper combustion and the
exhaustion of gases through the chimney (flue) of fuel burning
equipment to prevent back-drafting. See the standards of NFPA
(National Fire Protection Association) and ASHRAE (American
Society for Heating Refrigeration and Air Conditioning Engineers)
and the local building code authorities.
9. Do not use this fan with any solid state control device, such as
a remote control, dimmer switch, or certain timers. Mechanical
timers are not solid state devices.
10. This ventilation fan is approved for use over a bathtub or shower
when installed in a GFCI protected circuit. Do not use fans over a
bathtub or shower that are not approved for that application and
marked accordingly.
11. Do not install in a cooking area. or where the room air temperature
will exceed 104
o
F (40
o
C).
12. Do not use to exhaust hazardous or explosive vapors.
13. Fans should always be vented to the exterior and in compliance
with local codes and avoid any sharp corner, area reduction or
unnecessary angles on ducking. Do not vent exhaust air into
spaces within walls or ceiling or into attic, crawl spaces or
garages.
14. Do not install in a ceiling with insulation greater than R42.
15. Duct work should be installed in a straight line with minimal bends.
16. Duct work size must be the same size as the discharge and should
not be reduced. Reducing the duct size may increase fan noise.
17. Prior to service or cleaning this unit, shut off power supply at the
panel and lock to prevent the power from being turned on. If the
panel cannot be locked, clearly mark the panel with a warning tag
to prevent the power from being turned on.
18. Use this unit in the manner intended by the manufacturer. If you
have any questions. Please cali customer service.
General safety information and warnings
Please read and understand this entire manual before attempting to assemble, operate or install the product.
