Nautel VS1, Руководство по устранению неисправностей

Страница: 94 / 109

VS1 Troubleshooting Manual Mechanical Drawings
Issue 10.0 2018-10-29 Page 6-1
Section 6: Mechanical Drawings
This section contains mechanical drawings for assemblies of the transmitter. Dimensional
drawings may be included. Refer to
Table 6.1 on page 6-2 for an itemized list.
Assembly detail drawings for assemblies and modules that have separate manuals are not
included. Refer to the appropriate maintenance manual for the assembly detail of these
assemblies.
Identifying mechanical drawings
Each mechanical drawing in this section is identified by a number that is both the figure
number and the page number. The numbers are assigned sequentially and are prefixed by the
letters
MD
. Drawings in this section are listed in Table 6.1 on page 6-2 .
Content of mechanical drawings
Mechanical drawings are illustrations that depict the location of electrical components and
show assembly outline detail. Dimensional information is included, where appropriate.
When a module or assembly is the subject of its own assembly detail drawing, and it is also
shown in a higher level assembly, the detail depicted in the higher level assembly may have
minor differences from the module or assembly actually installed. In this case, always refer to
the assembly detail drawing of the module or assembly for detailed information.
Locating a part or assembly on a mechanical drawing
1. When a part or assembly is assigned a reference designation (e.g.,
A2
or
A2R1
), refer to
the family trees in Section 3, “Parts Lists” on page 3-1 . Follow the family tree branches to the
block that contains the desired reference designation and Nautel nomenclature (e.g.,
NAPA23/03A PA PWB
). Note the reference designations and Nautel nomenclatures of all
higher assemblies in the path, as applicable.
Example:
A6 NAPA23/03A PA PWB
.
2. Refer to Table 6.1 on page 6-2 . Use the reference designation and Nautel nomenclature to
identify the appropriate mechanical drawing.
Example:
NAPA23/03A PA PWB
is shown on schematic
MD-7
.