
–
If Otocam 300 is not placed in its cradle, the light beam is switched on.
–
If Otocam 300 is placed in its cradle, the light beam is not switched on.
Note
•
In order for the pre-heater to heat the camera tip to body temperature, Aurical Otocam 300 should remain in
the cradle (connected to a PC which is powered on) for minimum 5 minutes before the camera is used. The time
should be extended if Aurical Otocam 300 has been stored in a cold environment.
Warning
•
Do not stare into the light beam, or point the light beam in the direction of other people’s eyes. It can
damage the eyes.
Switching off Aurical Otocam 300
To completely switch off Otocam 300, disconnect the USB cable from the computer.
3.6
The Aurical Otocam 300 cradle
The cradle is a multi-functional holder for your Aurical Otocam 300 when it is not in use. It controls the light source and
the camera tip heating.
When Aurical Otocam 300 is placed in the cradle, the light source is turned off and the camera tip heating is turned on.
No condensation problems
In most cases the camera tip has a lower temperature than the air in the ear canal. This causes condensation, which
reduces the image quality.
In Aurical Otocam 300 the built-in heater pre-heats the camera tip so that the temperature difference between the cam-
era tip and the air inside the ear canal is minimal. The pre-heating function is activated when the Aurical Otocam 300 is
plugged into the PC (which is powered on) and placed in its cradle. In order for the pre-heater to heat the camera tip to
body temperature, Aurical Otocam 300 should remain in the cradle for approx. 5 minutes before the camera is used.
Therefore, for optimal operating conditions, place Aurical Otocam 300 in the cradle when you are not using it.
10
Aurical Otocam 300
3 Unpacking and Installing