NatureWater SOFT-HB1B, Руководство по эксплуатации

Страница: 24 / 27

https://www.naturewater.eu Item 63922, 63923 Page 24
11 2023-1
Adjustable
parame-
ters
Parameter setting method Display
Time
If “12:12” flashes continuously, the current time must be
reset.
1. In the position “water supply,” press the button
to call up the user interface shown in Fig.
A1. The default setting “Set clock” is selected.
2. Press the button again to call up the menu
for setting the current time, as shown in Fig.
A2. The hour “12” flashes. Press the up or
down button to set the hour.
3. Press the button again, the minutes “12”
flash. Press the up or down button to set the
minutes.
4. Press the button again to permanently
change the current time. Press to return to
the initial display.
Fig. A1
Fig. A2
Regenera-
tion time
1. In the “water supply” position, press the button
to call up the user interface shown in Fig.
A3.
2. Press the down button, select “Set Regen
Time,” and press the set button to call up the
menu as shown in Fig. A3. The hour “02”
flashes. Press the up or down button to set the
number of hours.
3. Press the button again, the minutes “00”
flash. Press the up or down button to set the
number of minutes.
4. Press again to save the modification of the
regeneration start time, then press to return.
Fig. A3
Water
hardness
1. In the operating position, press to call up
the user interface shown in Fig. A4.
2. Press the down button, select “Set Water
Hardness,” then press to call up the “Set
Water Hardness” menu as shown in Fig. A4.
The number “350” flashes. Press the up or
down button to set the raw-water hardness.
3. Press again to save the modification of the
row-water hardness, then press to return.
Fig. A4
After setting the parameters, switch on the water inlet switch and observe the operation of the water
softener. In the water-supply position, press the button so that the machine automatically switches to
service mode to rinse the resin. At the same time, check that no water is leaking from the individual
components and that no resin is leaking. During normal use, the user does not need to carry out any
further work on the softener, but simply needs to add a certain amount of salt to the brine tank at regular
intervals.