Nature Power 38326, Руководство пользователя

Страница: 14 / 15

Page 14
6. TROUBLESHOOTING
To troubleshoot the unit, please note the error code displayed on the main unit and review
“Understanding the Error Codes” in section 4.
Problem Symptom Solution
No output
voltage. And
Status LED is
off. The unit is off Turn unit ON by following the instruction in
Section 4 to turn unit ON
No power to unit Check DC fuse, Disconnect switch (if
installed) and check if Branch breaker is
either blown or turned OFF
No AC output.
Status LED is
Green GFCI is tripped Check load and reset the GFCI
No Output.
Status LED is
in Amber GFCI is tripped
Check error code on display
Check AC Load Sense setting Check load and reset the GFCI
Verify the error condition and make
correction
AC Load connected must be below the AC
Load sense setting
7. SPECIFICATIONS
Note: Specifications are subject to change without notices.
Specification 38326
Inverter
AC Output Power 2000W
AC Output Current 16.6A
AC Surge Power (Peak) 4000W
AC Output Voltage/Frequency 120 VAC / 60 Hz
AC Output Waveform Sinewave (<3% THD)
Nominal DC Input Voltage 12.5 VDC
No Load battery draw < 1.5 ADC
DC Input Voltage operating range 10.5
– 15.5 VDC
Under Voltage Alarm 11.0/12.1 VDC
Under Voltage Alarm Recovery 11.3/12.3 VDC
Under Voltage Shutdown 10.5/11.8 VDC
Under Voltage Recovery 12.0/12.6 VDC
Over Voltage Shutdown 15.5 VDC
USB
USB Port 5V, 750 mA
AC Transfer Switch
Transfer Time < 30 ms
Transfer Relay Rating 30A
AC Input Source Setting 15, 20, 30A
AC Output Port 1 (HW Connector) 30A
AC Output Port 2 (HW Connector, GFCI, CB) 20A
AC Output Port 3 (GFCI & CB) 20A
Display
Display Panel Port RJ12
Inverter Mode Input Voltage, Output Power
Charger Mode Status & Battery voltage
Charger
Charging Voltage Range 13.5 -14.4 VDC
Float Voltage Range 13.4
– 13.8 VDC
Charger Current (max) 55 ADC
Charger Current Setting 5,15,35,55