Native Instruments Absynth 5, Справочное руководство

Страница: 54 / 204

ABSYNTH 5 Reference Manual – 54
•
Phase Sync switch
: Setting the Phase Sync switch to Phase will reset the phase of the oscil-
lator with every incoming MIDI note. When the Phase Sync switch is set to Free, the oscillator
will not be reset. When only one oscillator is active and you have set one voice in the Uni
panel, the mode Free has almost no effect. When you have a higher Unisono number of
voices or multiple active oscillators, every note leads to an audible change in the sound.
•
Phase control : Sets the phase of the Oscillator. The effect is only audible if a second
Oscillator is active. This parameter is useful when using integer values for frequency ratios
between carrier and modulator, as it is the case in FM.
5.4.4 Double Mode
Oscillator in Double mode
In Double mode, a pair of oscillators – consisting of the Main oscillator and the Mod oscilla-
tor – is active. The signals of the two oscillators are mixed.
On the Main panel, you will find the same parameters as in Single mode. For more info on
these parameters, please refer to the section
5.4.3, “Single Mode” , above.
On the Mod panel, the following parameters are available:
• Balance control
: Controls the balance between the oscillators Main and Mod within the
Oscillator’s output signal.
•
Waveform Selector : This opens a dialog where you can choose the Waveform for the Mod
oscillator (see section 5.3.1, “Waveform Selector and Waveform Selection dialog” , above
for details).
• Frequency menu and Frequency control
: Enables you to enter the oscillator’s frequency as
a transposition of the played note (Trans), as a relationship (Ratio) with the played note,
as a fixed Frequency (Hz) or via a fixed MIDI note (Note). See section
5.3.2, “Frequency
Menu and Frequency Control” , above for details.