If you have any questions concerning these instructions, please call National Customer Service
800.482.1717
.
Assembly Instruction
1610 Royal Street
Jasper, Indiana 47546
Telephone 800.482.1717
Fax 812.482.8800
www.NationalOfficeFurniture.com
3248959
Rev, B
LOCHLYN
FREESTANDING FRAME
BUILD
4
7
Begin with one of the end frame sections and place the appropriate horizontal bars
over the junction blocks
(Figure I)
.
Note 1:
Ensure the horizontal bars are aligned properly. The extruded lip (if applicable)
should face the interior of the frame section and the counter sunk holes should face
down towards the glides.
Note 2:
On some frame units, there are different length horizontal bars from one column
to the next. Reference the Model AI Sheet to determine which length bar is correct.
CAUTION:
Do not
deviate from the provided Model AI Sheet and install different
frame lengths to different columns. This will cause issues with installation of modules
and shelves and will make the unit unstable.
8
Start and tighten a screw through the horizontal bar
into the junction block to secure the bar to the
frame
(Figure J)
. Install all bars to this sub
-
assembly
section.
CAUTION:
An impact driver may be used but
excessive driving can strip the threads in the block. Stop
driving immediately after there is audible impacts. If a
drill driver is used, a lower clutch setting is
recommended. Stripping the threads in the junction
blocks will render the unit unstable.
FIGURE J
FIGURE I
Note 1:
Note 1:
